Shifting index when all points have index 0... to create steps...

Trying to draw the horizontal tread between two points, one set from the intersection of horizontal curves with the section line, the other set the same but moved off the curve. I can draw the vertical riser fine between these two sets, but the horizontal I can't. I thought of shifting one of the indexes but the list seems to all have the same index, 0.

Suggestions appreciated!

Replies to This Discussion

Permalink Reply by Riccardo Majewski on April 3, 2016 at 6:27am

The tree structure of your last components have branches with just 1 item inside each.

Inside each branch ANY index will point to the same single object.

On you CCX component try to flatten it "P" output (right click over it), or if you want to keep some tree structure (if there is, but it seems not) use the "Trim tree" component.

With flattened/trimmed data you should be able to shift values and achieve what you want.

For further help, please post your definition (with internalized geometries).

Cya :D

RSS