set multiple curves, move, offset and loft

Hi,

It is my first definition thats why probably it is very easy question/problem.

I am modeling rectangles in rhino and then transform them i grasshoper. transformation parameters are conected with distanse between particular rectangle and point.

with separate definition for each rectangle can control more or less all:) but definition is extremaly long and not so flexible.

I want to create definition using set multiple curves but then i get lot of problems with indexes. Please let me know how i can correct my approach.

Best

karol

Attachments:

KAROL_gh_test.ghx, 6.1 MB
KAROL_gh_test_multiplay selection.ghx, 323 KB
karol1.3dm, 46 KB

Replies to This Discussion

Permalink Reply by Karol Wawrzyniak on December 1, 2010 at 1:28pm

hey,
got some solution but it is still too complicated comparing what i can find in books.
you can do it with weave component....
please check out my definition. some more advance users said that it should be simple in older verions like 6...

Attachments:

Permalink Reply by Kamil Kiendzierski on December 1, 2010 at 4:00pm

Something like this in attatchment?

Kamil

Attachments:

KW problem.jpg, 765 KB

Permalink Reply by Karol Wawrzyniak on December 1, 2010 at 4:27pm

i thougt it wont work but i chack it out and it is not working exaxlty how i intended but it looks like it solwed my my basic problem:)
thank a lot dude:)
(now i have to work a little bit with panels in order understand well:))

Permalink Reply by Kamil Kiendzierski on December 1, 2010 at 4:28pm

You can also make multiple curves/grid and connect them to Crv component instead RecGrid, use set multiple curves option.

Permalink Reply by Karol Wawrzyniak on December 1, 2010 at 4:40pm

ok i will work on it.
move and offset should be connected with distance between center point of cure and external rhino point.
hope there wont be any tree problem there;)

RSS