Selecting plane facing west

Replies to This Discussion

Permalink Reply by Dedackelzucht on April 3, 2012 at 2:17am

How about this one?

Best Regards

Dedackel

Attachments:

• westwindow_DeDackel.gh, 8 KB

Permalink Reply by zhengwei Quah on April 3, 2012 at 7:21pm

Hi Dedackel, thanks for the reply. Really appreciate that! Especially the faces which respond to point in the curve. Didn't know that before.

1.But after playing around with your definition, i found that the faces dont quite respond to the point in the circle you made. i tried to replicate one circle for every layer of boxes but obviously it didnt work  

2.Also, after getting offset lines and original edges of the surfaces, i tried to make them a planar surface/loft but i could make a 'frame' out of it. could you please enlighten? i am guessing that's because of the handling of data didnt go so well for grasshopper?

3.And what I intend to do in the end is box like the one below which has controllable permeability, but I couldn't find any component to replace one side of particular surfaces with new frames (assuming I would be able to make that in grasshopper finally). I've tried "culln" but it was not any successful. 

long question, but really glad if you could help =]

Attachments:

• westwindow_DeDackel_updated.gh, 10 KB

Permalink Reply by Dedackelzucht on April 4, 2012 at 2:39am

Hey,

I am not sure if I understand you correct.

But have a look at this file.

Best Regards

DeDackel

Attachments:

• westwindow_DeDackel_2.gh, 15 KB

Permalink Reply by zhengwei Quah on April 4, 2012 at 2:57am

sorry dedackel can you post a print screen of your definition because some of the components obviously missing =[ thanks!

Permalink Reply by Dedackelzucht on April 4, 2012 at 3:01am

Permalink Reply by Faith Sa on March 1, 2017 at 7:19pm

You may want to take a look at this page:

http://www.grasshopper3d.com/group/ladybug/forum/topics/south-facin...