select line

Replies to This Discussion

Permalink Reply by David Rutten on December 16, 2014 at 3:35am

Attachments:

• line angle selector.gh, 9 KB

Permalink Reply by Silvia Ciao on December 16, 2014 at 7:41am

thanks for your Grasshopper definition! But I don't understand very well the values of the domain.. The start and end numbers don't indicate the real number I want, right? I want a domain that include the mubers between pi/4 and 3/4*pi...

Permalink Reply by David Rutten on December 16, 2014 at 8:23am

pi/4 is the same as 0.25*pi and 3/4*pi is the same as 0.75*pi

The sliders just set the multiplication factor, and the pi comes into it through the expressions on the Domain input parameters (the little asterisks in front of A and B)

Permalink Reply by Silvia Ciao on December 16, 2014 at 8:50am

Ok, now I understend! Thank you very much!!