Grasshopper

algorithmic modeling for Rhino

Select interior and exterior surfaces

Hello everybody,

I am currently trying to define the surfaces of a building. For the moment, I succeeded in separating roof, walls and slab. In the case of a single floor building, there is no problem but I am facing problems when I add a floor or interior walls.

My question is very simple : How can I separate interior surfaces from exterior surfaces in any case ?

Thank you in advance,

Best

Réda

Views: 423

Replies to This Discussion

Permalink Reply by Hannes Löschke on April 27, 2014 at 11:16am

The question is simple, the answer is not. You might find some clues looking at your data at hand.

Looking at how the surfaces join might be a good point to start. Outside walls will probably share the same edge with other outside walls, while inside walls probably just extend to the next outside wall... But that's just a wild guess.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service