Grasshopper

algorithmic modeling for Rhino

Select and Remove Surface

Hi everybody,
I'm trying do make a 3D voronoi based structure and I would like to uncap the faces that are in contact with the borders of my box, to see the "structure" of the voronoi.

There is someway to do it?

I already tried with the dispatch command, but a can't select only the surfaces that are in contact with the box. In addition, I also tried using the inside command but I couldn't make it work.

Thanks in advance for the help

Views: 3011

Attachments:

Replies to This Discussion

Permalink Reply by Manuel Oliveira on October 21, 2012 at 6:08pm

Ok, got it :)

Thank you, once again for your assistance Michael

Permalink Reply by Chris Tietjen on October 21, 2012 at 6:13pm

That's nice Michael,  I wouldn't have gotten that.

Permalink Reply by Chris Tietjen on October 21, 2012 at 5:36pm

That's it.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service