Grasshopper

algorithmic modeling for Rhino

section plane through brep issue

I've spoken with David about an issue I am having and he says it's a bug - but I'm wondering if anyone has experienced it and maybe has a work around. I use a plane to create a curve as it sections through a brep surface, but often times these curves are not closed - which isn't really possible since the surface is untrimmed and intact. I need the curves to be closed in order to trim the same surface...

Views: 410

Replies to This Discussion

Permalink Reply by Dirk Anderson on June 21, 2009 at 6:50am
Gabriel, you have to post screen shots with your issues... helps with understanding the problem. Did David mention it was a tolerance issue...
Permalink Reply by Gabriel on June 21, 2009 at 6:57pm
thanks Dirk. You're absolutely right on all accounts.

I am finding that more and more all the problems I experience have to do with tolerances...Thanks so much

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service