Seam curve and lofting problem

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 4, 2017 at 3:37am

I suppose your section profile curves for loft are probably degree 2, and the location of the surface seams are where "Knot" is located.

You can simply get rid of this by using "Rebuild Curve" with over degree3+ proper num, of cp count.

Permalink Reply by lukdamore on August 4, 2017 at 3:58am

Hello Hyungsoo Kim

Thanks for your message :)

I tried to follow your advice but I loose a little pit the shape...and I also have another problem of "Unclosed" loft.

Maybe I didn't do all the necessary steps you told me... :S

Permalink Reply by Hyungsoo Kim on August 4, 2017 at 5:44am

I don't understand what you are talking about. What seems to be the problem?

Attachments:

• Lotustowers2_re.gh, 39 KB

Permalink Reply by lukdamore on August 5, 2017 at 1:23am

Thank you so much Hyungsoo Kim!

:)