Running Octopus Problem

Dear friends,

I am new in Octopus. I followed the instruction to install it and then use it.

first: when I set up an optimization problem and try to run Octopus, it does not open its editor and does not work.

second: when I close the Grasshopper file and open it again, I get an error message (attached file) and after that, the Octopus component has been removed from the script.

I would appreciate it if somebody could help me to solve the problem.

Thanks in advance,

Saeed

Attachments:

OctopusError.jpg, 130 KB

Replies to This Discussion

Permalink Reply by Olivier Dambron on November 9, 2016 at 9:21

Hi Saeed,

In the grasshopper component folder make sure the files for octopus are unblocked.

Click right and tick unblock.

Close rhino and gh and reopen.

Let us know
Olivier

Permalink Reply by Saeed on November 9, 2016 at 10:03

Hi Oliver,

Thank you very much for your consideration and respond.

I did it and it is working now!

Saeed

Permalink Reply by Amaraa on November 14, 2016 at 7:50

Hello

Just a simple note.

Make sure unblocking every grasshopper plug-ins after downloading, whether its zip or normal files, is very important and I have encountered this issue too.

Good luck.

-Amaraa

Permalink Reply by Saeed on November 14, 2016 at 14:00

Hi Amaraa,

Thanks for your comment and advice.

Best,

Saeed

Permalink Reply by Saeed on November 21, 2016 at 4:56

Hi Iris,

On my experiences so far, just when the file is blocked you will see the "unblock" option in the properties window. When the file is not blocked, probably you have something like the attachment "00".