Grasshopper

algorithmic modeling for Rhino

Ruled Surface Problem

Hi,

I created a spine (like the spinal chord) and by creating points and interpolating between them. Then I offsetted the curve in both ways. Then I used the RuleSRF tool to create a surface between the two offsetted curves. My problem is that the created surface is not actually filling the whole area between the external curves as shown in the picture. Can anyone explain why is this happening? and how to fix it?

Views: 1604

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on January 22, 2015 at 8:16am

It is just a preview mesh setting problem.

You can change it to "High Quality" or "Document Quality"

Permalink Reply by Ibrahim Abotaleb on January 24, 2015 at 4:01am
Thank you :)
Permalink Reply by Hannes Löschke on January 22, 2015 at 8:16am

Set grasshopper preview meshing (light blue icon top left corner) to fine or document. See if the problem persists.

Permalink Reply by Ibrahim Abotaleb on January 24, 2015 at 4:02am
Thank you :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service