Rotating glazing based on ratio models

Replies to This Discussion

Permalink Reply by Abraham Yezioro on June 7, 2015 at 10:26pm

Robert,

Any transformation MUST be applied BEFORE you get to HB components. See attached.

Don't see any issue with the visualization on my side.

-A.

Attachments:

• SIM_03_AY.gh, 569 KB

Permalink Reply by Robert Doe on June 7, 2015 at 10:47pm

Okay, thanks Abraham.

Permalink Reply by Robert Doe on June 8, 2015 at 2:15am

Hey Abraham, I keep tripping up over these components; Run Energy Simulation; Generate EP Output. Attached to your files as May 31st and June 7th versions respectively. But when I download the latest HB (just now) I get Run ES May 31st with no HBGenerators input; and Generate EP Feb_01_2015 not Jun_07_2015 - so this component is generally not working now. You can see the latest versions I can get on the PDF attached and I assume the same for all. Or is it? R.

Attachments:

• HB Generators.pdf, 878 KB

Permalink Reply by Abraham Yezioro on June 8, 2015 at 7:06am

For some reason the rhino file dissapeared for download (you probably deleted it). The file i uploaded doesn't have the geometry internalized ... and i also deleted all fiules from my computer.

So ... can't check properly your question. I've just updated the file. Also reinserted a couple of components 9and left the previous, so you can tell what i did).

Hope it runs well on your side. If don't upload a file with geometry internalized.

-A.

Attachments:

• SIM_03_AY.gh, 586 KB

Permalink Reply by Mostapha Sadeghipour Roudsari on June 12, 2015 at 3:05pm

This is the results of a new part of the development. Is this problem re-solved?

Permalink Reply by Robert Doe on June 12, 2015 at 6:42pm

Yes thanks. Abraham set me right.