Grasshopper

algorithmic modeling for Rhino

Rotate3D and attractor line

Hello!

I'm attempting to rotate the circles in the X and Z axis. Each one being rotated individually from their own center (like in the sketch), and the angle of rotation being influenced by the attractor line. So far I can only make them rotate all together from either a common reference point or from the attractor line (like the green circles in the picture below).

I attached the definition, any help would be very much appreciated.

Views: 486

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on May 21, 2015 at 10:37pm

Is it what you are after? I'm not sure.

Attachments:
Permalink Reply by Hyungsoo Kim on May 21, 2015 at 11:01pm

This one is "Flap" version.

Attachments:
Permalink Reply by Helena Zambrano on May 22, 2015 at 12:31pm

Thank you so much Hyungsoo! This is really really helpful!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service