Grasshopper

algorithmic modeling for Rhino

Rotate axis component loses curve reference when reopening file

One of the Rotate axis components I have in a GH file always loses the curve reference when I reopen the Gh file. All the other rotate axis components in the file work it's just this one component that always forgets.

 
I have the rhino.3dm file open first then I open Gh and load my file and every time the reference is gone from the list.
Attached are images of the problem.
Thanks for any help on this
RM

Views: 408

Replies to This Discussion

Permalink Reply by Roland M on July 18, 2013 at 10:19am

I found even if I replace the components the error shifts to another component and if I replace that then to another and another on down the line until it cycles back to the first replaced component.

Any ideas on what this could be?

RM

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service