Grasshopper

algorithmic modeling for Rhino

Rose Curve - order for interpolating points

Hello Grasshoppers,

I am a beginner, and am trying to create a "rose curve" using a series of points. I cannot get an interpolated curve to run through the points in the correct order (I would like it to just loop around the four 'petals' of the rose seen in attached image). I think this probably has something to do with 'lists', but need some help understanding how.

Could anyone offer some advice? Rhino image and ghx file attached.

Thank you very much.

Dave

Views: 1239

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by JS on November 23, 2013 at 11:51am

Set your domain to 0-2PI

Although what you did looks pretty cool.

Attachments:
Permalink Reply by David Graham on November 23, 2013 at 12:43pm

Thanks JS, however making the domain 0 - 2pi seems to affect the other roses created when I change the d and n variables. I am trying to create the roses in the attached jpeg.

Any other ideas?

Attachments:
Permalink Reply by JS on November 23, 2013 at 7:37pm

Sorry David, I'm kinda new at this as well. I'm not sure why my fix screws up the other roses. Hopefully someone else can chime in.

Permalink Reply by JS on November 24, 2013 at 6:26am

Try this. It's not perfect but it's about the best I can do. I increased the 2PI to 12PI.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service