Roof sloped and attach with wall

Hi, I have a difficult to create this Roof, with a strange curved form, but the difficult for me is inclinate the roof and in someway have the wall that follow the roof, became all one with that, i think it's easy, but i don't how can i do that

Thank you in advance :)

Attachments:

CRISTODIOCHEFOLLIA.JPG, 199 KB
CRISTODIOCHEFOLLIA2.JPG, 128 KB

Replies to This Discussion

Permalink Reply by lorenzo glielmi on September 25, 2016 at 3:43am

nobody know it ? :(

Permalink Reply by Yasser Mehanna on September 25, 2016 at 8:30am

is that what you'r looking for?

Attachments:

matching walls with slop.gh, 11 KB

Permalink Reply by lorenzo glielmi on September 25, 2016 at 3:20pm

Yess perfect, but in my project doesn't work, it say: 1. Planar surface routine returned no results (in the "boundary Surface") :(

Permalink Reply by Matt Gaydon on September 25, 2016 at 4:03pm

You need to make the domain of the x and y of your plane that your projecting onto equal to or large than the size of the curve your projecting (Currently its missing in places). Also check the curve your projecting is closed. This should then solve the issue with the boundary surface not being created.

Permalink Reply by lorenzo glielmi on September 25, 2016 at 4:19pm

Thanks a lot! now it work!! :) I think if i use the same concept for the single wall, and repeat that with the same value, i think it would work! :D

Permalink Reply by Florino Ita on September 25, 2016 at 8:36am

I was wondering what is the interest of creating a house 3D model in grasshopper?

Permalink Reply by lorenzo glielmi on September 25, 2016 at 3:30pm

it's a project for University, but i find many difficult with revit becouse of its all spline, so i try to use Rhino+Grasshopper and i'm learning much things!

RSS