Rhino crashes when trying to open a file I just worked on!

Replies to This Discussion

Permalink Reply by David Rutten on July 4, 2017 at 8:52am

It takes a while to load but it runs here. I'm trying it on RhinoWip though, not Rhino5.

One thing you can try is to disable the solver before opening the file. Once the file is loaded but not solving, you then disabling all components. At this point you can enable the solver again. If you save the file now, you should be able to open it again in the future without crashing.

Then starts the arduous task of re-enabling components from left to right until you find the one that's causing the crash.

Another thing you can try is to switch to RhinoWip. Since there won't be any more releases of Grasshopper for Rhino5, even if there's a bug I can fix, it will never be available for Rhino5.

Permalink Reply by Shay Tavori on July 4, 2017 at 12:01pm

Thank you so much!

Permalink Reply by Shay Tavori on July 4, 2017 at 12:51pm

Such a strange thing... The problem was caused by a few generic curve components which had internalised data on them... The data was curves generated by GH!  Anyway, I solved it! Thanks so much you saved my day!  a true legend  :)

Permalink Reply by vhoang on July 4, 2017 at 9:34am

Works fine on my machine, Rhino5 SR14.

Permalink Reply by Shay Tavori on July 4, 2017 at 12:02pm

Thanks!