rhino 5: surface control points

Replies to This Discussion

Permalink Reply by David Rutten on May 10, 2013 at 4:34pm

Sometimes they are at the corners, sometimes they are beyond the trimmed region. I don't think Rhino5 differs much from Rhino4 in this respect. What matters is how you create the surface. Whether you end up with a trimmed or untrimmed surface.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Jon Bailey on May 11, 2013 at 9:21am

What is weird is that i tried this in both 4 and 5 with different results. I created a rectangle and did a planar srf command. In 4 control pts were at the edges but in 5 they were offset.