Grasshopper

algorithmic modeling for Rhino

Reverse U and V coordinates !!!

Hello every body !
I just wonder, how could i reverse the U and V coordinates of a surface in grasshopper ?
Is it possible ?
And second question, why "dim" (Surface-analysis-dimensions) is an approximate u and v surface dimensions? because i don't need an approximate but the real dimensions !!!

Thank you

Views: 321

Replies to This Discussion

Permalink Reply by Danny Boyes on October 20, 2009 at 8:16am
I too would love to see this and as David definitely saw this thread it might happen you never know
http://www.grasshopper3d.com/forum/topics/component-wish-surface
Permalink Reply by Theunis du Toit on October 20, 2009 at 9:37am
Maybe this image below can answer your second question?
Permalink Reply by Theunis du Toit on October 20, 2009 at 9:39am
The component can only measure one U and one V value, but there are two edges for each. So it seems that it takes the maximum intervals. I could be wrong but this is my best guess.
Attachments:
Permalink Reply by Brice on October 21, 2009 at 3:38am
Ok, sure..... I understand...

Thank you!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service