Reticular truss under floor

Hi everyone, I got a problem with the script below.

I made a reticular truss under a surface (I'm attaching the script) and now I want to extrude this surface to create a floor, but when I do that the truss loses its original geometry and it adds a specular truss also above the floor (of course I want it only underneath).

Could someone help? Can't figure out how to solve the problem...

Thanks everyone!

Attachments:

Trave reticolare parametrica.gh, 66 KB

Replies to This Discussion

Permalink Reply by Dedackelzucht on October 6, 2015 at 1:05pm

Watch out with your inputs to the contour component (One Srf to S;and 1 Pt to contour start pt)

See file (sorry I had to order it to my logic:-))

Best Regards

DeDackel

Attachments:

Travereticolareparametrica_DeDa.gh, 66 KB

Permalink Reply by Andrea Casalboni on October 7, 2015 at 2:31am

Thanks for your interest in my discussion DeDackel ;-)

I'm not quite sure it works regarding my needs, now the truss is not 3D anymore.. but apart from this, my only problem is that the extrusion of the floor gives me one truss for each side of the floor itself. I don't know how to delete the upper truss to maintain only the lower one..in your script I can't see the extrusion of the floor though :-/

RSS