Responsive surface angles

Replies to This Discussion

Permalink Reply by diego on August 5, 2009 at 12:37pm

Hi claudio, try flatteningthe inputs in the angle component, i tried but it was a bit to much information for my laptop right now, so it crashed..., That will sure give you all the angles, you would ave to check the rest of the definition to get the data paths right so it will al work.

diego

Permalink Reply by Claudio on August 5, 2009 at 2:14pm

yeah i know I'm also on my laptop so it crashes as well. I'll take a look in my computer at work see what it does
Muchas gracias

Permalink Reply by Claudio on August 6, 2009 at 8:42am

Hey Diego I've try the definition at my office and it works. I guess I always understimate the flattening procedures

Muchas Gracias nuevamente

Permalink Reply by diego on August 6, 2009 at 9:23am

Glad to know it works, i know what you mean, i usually have a lot of trouble matching data to get it my definitions to work the way I want to.