resolution of point on curve component

Replies to This Discussion

Permalink Reply by Florian Frank on February 13, 2013 at 10:27am

Hi roderick,

The "Point on Curve" compontent is thought to be a fast tool to get points on curve e.g middle point ect. and there is no need for addicional decimals...You should use the "Evaluate Curve" component...Get sure to reparameterize the Curve (C input).

What do you mean by the wire display for the component?

Cheers

FF

Permalink Reply by Hannes Löschke on February 13, 2013 at 12:40pm

Wire display options require the parameter to be accessible and only works for wires connected to the parameter. So there is no way to change that for PointOnCurve.

You can work around that by routing through a cuve param and hiding the wire to this param.

Permalink Reply by roderick read on February 14, 2013 at 2:09am

Florian, Thank you.

I've been staring at the screen too much. How did I miss that?

I imagined I'd have to divide a curve into 9999 lengths,  filtering out a domain of points above and below a set value...

I think I'll stick to your elegant solution ...Ta