Grasshopper

algorithmic modeling for Rhino

Reset Kangaroo

Hi there,

I don't know if it's a stupid question, but using kangaroo, when I close grasshopper and reopen the file, I must to reset the simulation and restart it, because otherwise I don't see anything. There is a way to preserve the resolution made ​​before closing the program even when the file is reopened?

Views: 844

Replies to This Discussion

Permalink Reply by Daniel Piker on April 10, 2013 at 3:43pm

Not a stupid question at all.

The data created within Kangaroo's iterations does not currently get saved with the Grasshopper file.

What you could do is connect a 'Geometry' parameter to the output, and after reaching a result from the simulation right click it and choose 'internalize'

Its data then becomes separated from Kangaroo and is embedded in the ghx, and will be there again when you re-open the file

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service