Repetitive actions - help on combining them

Hi guys! I am trying to create a single raw of herringbone pattern captured between and controlled by four base lines.

It is not very complicated, but for creating each `bone` of the pattern, there is an action which depends on result of the previous similar action. So if I want 20 pattern `bones` I have to copy and paste and manually plug them 20 times. So it is not automated, I can not parametrically control the desired number of these lines.

Please suggest me something to cluster or combine them and make these actions run each time depending on the previous results of them.

Here is the snapshots and definition with internalized data.

I hope I could explain my problem clearly :)

Attachments:

08-10-2015.gh, 19 KB
result.png, 49 KB

Replies to This Discussion

Permalink Reply by Xny_Mogy on October 8, 2015 at 4:43pm

Image of code

Attachments:

whole code.png, 718 KB

Permalink Reply by Pieter Segeren on October 8, 2015 at 5:18pm

Hi Xny, this reminded me of an earlier discussion that might be helpful.

Permalink Reply by Xny_Mogy on October 9, 2015 at 6:32am

Thank you Pieter! This is quite solving the problem. The only remaining question is, after running it gets to the last point and shows only the last step. In the example you showed, there is no such problem and it shows all steps.

How do I get all intermidary steps - points, not only the last one?

Attachments: