Grasshopper

algorithmic modeling for Rhino

removing projected curves

Hi all,

I have a U shaped surface. I have positioned curves on it's outer periphery and am projecting these onto the surface. The problem is that the line project on both "arms" of the U.

How could I cull the extra projection so as to only have the left side curves project of the left arm and right side curves project on the right arm?

Views: 378

Replies to This Discussion

Permalink Reply by Dedackelzucht on September 7, 2012 at 3:20am

how about sortin g by distance?!

Best Regards

DaDackel

Attachments:
Permalink Reply by Peter Kluck on September 7, 2012 at 5:45am

Hi Dedackelzucht,

how about this one?

Best, Peter

Permalink Reply by Dedackelzucht on September 7, 2012 at 5:49am

Hey Peter,

thats a good one too. I guess it depends on his settings. Are there curves and lines on both sides of the u-geometrie, are they in the same distance to the traget u-geometrie? and so on and on....

Best Regards

DeDackel

Permalink Reply by Nick on September 7, 2012 at 10:01am

I've attached files for my issue.

I don't think the g distance way would work in this case...

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service