Grasshopper

algorithmic modeling for Rhino

Hi,

want to make diamond/trapezoid surfaces from the divide surface components like in the pic above:But not getting it like i want.

Anybody knwos how?

Thanks in advance!

Views: 1069

Attachments:

Replies to This Discussion

Hmm ...

... your walk to Utopia not started yet.

PS: Using the stuff that you are after.

Attachments:

And whilst China F1 qualifying is on the going (Lewis not flying > #$#$#$ ) get that as well

Attachments:

Use my mail just send

TAKE THAT Ferrari

0.186 on one run? Better keep your fingers crossed.

thanks Peter as always really nice! Did not get any mail. Going to try to solve the sardine challenge now, will send any progress, hehe.

 ... sardine challenge ...

Go for it. BTW: Just added this stunning cuppa for the brave winner:

I once ate this

so i dont fear this little sardines !

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service