Random polygon cap holes bevel

Hi ! I have to create the polygon look like Swarovski covent, I tried use voronoi generate random polygon, but I have no idea create the random cap holes bevel.

and the voronoi just generate the lank side, cannot generate zigzag line.

any idea ? please

(PS: I use Rhino 5 + Grasshopper 9.0056)

Replies to This Discussion

Permalink Reply by Vicente Soler on August 17, 2013 at 9:10am

From the image they look like hexagons cut at an angle. I'm not sure if the angle is the same or changing so I made it slightly random.

Permalink Reply by JackyCheung on August 17, 2013 at 1:20pm

Hi Vicente ! I appreciate your help very much. I have some question may be you can help.

Would you tell me the "Range" component stepts formula?

Original image look like is random quadrangle and hexagon, could you tell me how to generate?

THX.

Permalink Reply by Vicente Soler on August 17, 2013 at 1:55pm

The formula is "N-1".

I'm not sure if some of them are quadrilateral.

Here's another view:

http://www.vogue.in/sites/default/files/article/Big/988/Swarovski%2...

and a close-up (I think from another store):

http://farm5.static.flickr.com/4145/5182740009_761328a946.jpg

A hexagonal prism cut at an angle might look in a picture like it has less than 6 sides or is irregular, and it would also be more difficult and costly to pack them and build the different shapes, but I could be wrong and they are different.

In my definition the cutting angle is always perpendicular to the storefront, but it looks like it slopes towards any direction.

Permalink Reply by JackyCheung on August 17, 2013 at 2:27pm

Ok, I understood the fundamental principle.

I appreciate your helps!

Best thanks

RSS