Grasshopper

algorithmic modeling for Rhino

Random Offsets with differents lofts problem!

I have some problems with offsetting my surface to archive something like this Project

I don't know if i used the right strategy for recreating this project or not.

First of all i Offset the Surface, then I used isotrim to subdivide it into rectangles with the same width.

then i used cull patterns and offset the again to loft the remaining rectangles together.

the problem is that, I cannot create lofts with different depths and it will give me only to different loft. On the other hand, I don't have that much control on it like the source project.

Indeed I don't know how he could use actual designed units instead of the lofted ones in my script!

Views: 887

Attachments:

Replies to This Discussion

Permalink Reply by kaveh dadgar on May 14, 2016 at 5:39am

Hey Tom,

Thank you for the notice. I'll check it for sure.

Permalink Reply by Hyungsoo Kim on May 13, 2016 at 5:14am

Hi.

Is this what you are after?

Attachments:
Permalink Reply by kaveh dadgar on May 14, 2016 at 5:38am

That is exactly what i want. is there any way to set this random component only for 3 or 4 different numbers? i mean right now it gives us all the numbers between 3 to 6. but i want only 4 numbers that gives me for example 4 different units in the apartment.

thank you so much for your help Hyungsoo.

Permalink Reply by Hyungsoo Kim on May 14, 2016 at 9:34am

Check attached. Best.

Attachments:
Permalink Reply by kaveh dadgar on May 15, 2016 at 6:36am

Yes Thank you so much.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service