Radius of a circle

Replies to This Discussion

Permalink Reply by djordje on November 10, 2013 at 4:10pm

If I understood you correctly, you could use the "Curve" parameter to "take in" the curve from Rhinoceros to Grasshopper. Then a bit of "Area" component along with "Evaluate" will calculate the radius of your circle

Attachments:

• circle radius.gh, 2 KB

Permalink Reply by Erick Vásquez on November 10, 2013 at 4:19pm

Deconstruct Arc

Permalink Reply by Elbert Choquehuanca on November 10, 2013 at 6:30pm

 (versus radius).

P=perimeter
R=radio

Attachments:

• Radio_perimetro.png, 150 KB

Permalink Reply by Ahmed Hossam on November 11, 2013 at 5:25am

the circle is made in rhino and not in gh ...

Permalink Reply by Danny Boyes on November 11, 2013 at 5:30am

all the answers above are referencing geometry in Rhino and not making circles in gh

Permalink Reply by Ahmed Hossam on November 11, 2013 at 5:32am

danny boyes! ...

how to reference the circle from rhino into gh wasn't yet told ...

Permalink Reply by Danny Boyes on November 11, 2013 at 5:36am

its a curve. use the curve param and right click it and select "set one curve"

Permalink Reply by Ahmed Hossam on November 11, 2013 at 5:37am

thank you all! :)