Quick question: How to offset/extrude a circle/cylinder inwards?

Replies to This Discussion

Permalink Reply by Danny Boyes on September 20, 2010 at 3:20am

Hi Ra,

You could use the Offset Loose component. [v0.7.0055]

Permalink Reply by Ra on September 20, 2010 at 3:36am

Hey Danny,

Thanks but I'm still using v0.6.0059 'cause I'm using Rhino 4 (I think sr4). Would you by any chance know how to do it on the older version?

Permalink Reply by Danny Boyes on September 20, 2010 at 5:16am

Hi Ra, sorry I got delayed with replying, work hey!

For version 0.6 you would need to go back to the curves that you use to create the srf and offset those and then loft again in the same way.

Permalink Reply by Ra on September 20, 2010 at 6:55am

Hi Danny

Silly me! I must be spamming up the forums. Thanks a lot though! My laptop's going to hate processing this!

Hope work's going well.