Grasshopper

algorithmic modeling for Rhino

Pull curved surface

Hello together

I try to pull a surface in grasshopper, in the first attempt it worked. But now I want use the same on a curved surface but it doesnt works, have anybody tips ?

Views: 314

Attachments:

Replies to This Discussion

Permalink Reply by Kuznetz on January 31, 2013 at 8:48pm

Just flattern points  in surface grid component . But your surface is not good after divide surface (you can easy check it , connect SG to divide surface) . In this situation better generate lines from point and use loft.  

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service