proximity topologie

hi all,

under mesh is a very smart component called Proximity 3d with an output Proximity Topologie. What does it mean this output or how can I interpret it ?

Thanks in advance...

best

Benjamin

Replies to This Discussion

Permalink Reply by David Rutten on January 18, 2011 at 10:23am

Hi Benjamin,

the topology outputs for every point in the set a list of integers. These integers are the indices of the points that were connected. So this basically allows you to figure out which points were close, not just the lines between sets of close points.

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Mark Bechtel on April 1, 2017 at 12:46am

How could you create points from the indices or select the existing points identified from this output? I'm a beginner so apologies if this is a really basic question.

Permalink Reply by David Rutten on April 1, 2017 at 1:14am

You can use [List Item] to access objects in a list using an index.

Permalink Reply by Benjamin Ennemoser on January 18, 2011 at 10:38am