problem with LunchBox - Diamond Grid

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on May 1, 2016 at 2:08am

Hi.

This could be one way of removing seam line. Check attached. Best.

Attachments:

• RemoveLunchboxSeam.gh, 20 KB

Permalink Reply by fabdesign3d on May 1, 2016 at 3:03pm

Thank you Hyungsoo Kim,

Your help was very valuable.

Thanks again

Permalink Reply by fabdesign3d on May 3, 2016 at 3:52pm

Good evening, excuse me but I still have a problem and no vulnerability to solve it.

I replaced the surface "Loft" with a valid NURBS surface, but I still have the same problem.

Perhaps the prblem in "grasshoper" is in command "averange", but do not know how risolverso.

I apologize, but could you help me one last time.

Your help would be for me fondamendamentale.

I also apologize for my English, I'm Italian and I speak little English.

Thank you for helping me you are offering.

Attachments:

• v6pipe.3dm, 326 KB
• v6pipe.gh, 36 KB

Permalink Reply by Hyungsoo Kim on May 3, 2016 at 11:39pm

Hi.

It's not 'average' problem.

In this case, "create sets" doesn't work properly, so I replace it to " sort+Partition" list.

Attachments:

• v6pipe_rev2.gh, 36 KB

Permalink Reply by fabdesign3d on May 11, 2016 at 12:44pm

Thank you so much Hyungsoo Kim's, 

sorry if I answer only now, but thanks.

Good time

Permalink Reply by Chapulin Colorado on January 15, 2018 at 5:07pm

Hi, just for everybody fighting with lb seams, i found out that the with the mesh+ plug in this problem can be solved really easily: