Problem with honeybee_solve adjacencies component

Replies to This Discussion

Permalink Reply by Abraham Yezioro on April 30, 2016 at 1:24pm

Iman,

The process to create the zones should be different than what you propose (based on surfaces).

See attached a working file.

-A.

Attachments:

• testadjacencies_AY.gh, 471 KB

Permalink Reply by Iman Khayat on April 30, 2016 at 11:48pm

thank you Abraham for your answer.i knew that intesrsect component but it doesnt show the wall adjacencies in "read me pannel"! the problem is that its not working with the brep that are in the center of another breps!if i move it further it will work correctly and shows the adjacencies in read me pannel.i think it should be a problem from honeybee.

Permalink Reply by Abraham Yezioro on May 1, 2016 at 2:43am

Try the attached.

I used a different approach for the initial geometry. Didn't get why the previous were not working. Maybe something related to tolerances ...

-A.

Attachments:

• testadjacencies_AY1.gh, 471 KB

Permalink Reply by Iman Khayat on May 1, 2016 at 3:51am

thank you very much but its not working yet.your inner geometry wasnt in the center of the outer geometry.i fixed your new geometry but unfortunately its not working yet.i think its a modeling bug.i am completely confused! :)

Attachments:

• adjacencies.3dm, 108 KB
• testadjacencies_AY1.gh, 473 KB

Permalink Reply by Abraham Yezioro on May 1, 2016 at 4:18am

Weird,

See another try. I'm offsetting the external curve.. Moving the internal box by 2 mm works (see red group at the left). I think this is pretty much the middle. Don't get why the middle-middle is not working.

-A.

Attachments:

• testadjacencies_AY2.gh, 474 KB

Permalink Reply by Iman Khayat on May 1, 2016 at 4:27am

yes it seems that its not working just in middle-middle :)

i should give up modeling at center.i've never seen that error before.i hope it will fix soon.

thanks again and wish you the best Abraham.