Problem with Honeybee_Solve Adjacencies component

Hi all, hi Chris,

I am in trouble with the Honeybee_Solve Adjacencies component (the connection between internal zone and a ground floor) and i was not able to find the error in the workflow. There is something in the model that i cannot recognize as an error. Can someone help me? I am going crazy. The reed baloon says just this "1. Solution exception:bce01e33-8f6a-46ac-8de9-d1d1f728b0d0".

Attached you can find the file with all the data internalized.

Thanks in advance.

Best,

Angelo

Attachments:

Outdoor_Microclimate_Map_5_SIMPLIFIED.gh, 740 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on April 17, 2017 at 12:19pm

Angelo,

Can't reproduce the problem at my end. it works fine.

Check your tolerance (command units in rhino). Mine is set to 0.001.

-A.

Permalink Reply by Angelo Figliola on April 18, 2017 at 1:20am

Hi Abraham,

Thanks for the reply.

I also have set the tolerance to 0.001....I really don't know what happen with this component!

If you have any other ideas...you are welcome!

Best,

Angelo

Permalink Reply by Abraham Yezioro on April 18, 2017 at 2:35am

To be on the safe side, update your file to the latest version of HB.

Besides that, no much ideas ... Maybe recompute the script.

-A.

Permalink Reply by Angelo Figliola on April 18, 2017 at 2:34am

Hi Abraham,

I solved the problem. I opened the Gh files with the internalized geometry in a new Rhino file with the tolerance that you suggested. It's strange that works with a new Rhino file with the same tolerance value.

Thanks for helping me.

Best,

Angelo

Permalink Reply by Abraham Yezioro on April 18, 2017 at 2:47am

When you change the tolerance in rhino it is not automatically updated in GH. You need to recompute the GH to take the new value.

Glad it works.

-A.

Permalink Reply by Angelo Figliola on April 18, 2017 at 3:52am

I was thinking that the problem was solved.....but no! Again! I saved and re-opened the gh file again and the problems is still here!

The Honeybee version that I used is the latest.....i really don't know where is the problem..

Best,

Angelo