Grasshopper

algorithmic modeling for Rhino

problem with "hexagonal based" origami [solved]

Hi everybody,
I'm tring to understand the definition uploaded by Daniel Piker
http://www.grasshopper3d.com/group/kangaroo/forum/topics/new-origam...
What I'd like to do is to model the origami in the picture attached.
I have a problem with the hexagon since I didn't understand how to avoid its deformation.
I tried to put some sort of ties but I'm not sure how to make it works in grasshopper.

Thx.

Views: 1117

Attachments:

Replies to This Discussion

Permalink Reply by Daniel Piker on August 11, 2014 at 7:35am

Inside the Origami cluster, it assigns angles to mesh edges, depending on the input mountain/valley curves.

Here I've just added a 3rd set of edges 'Flat', which always try and stay at an angle of zero

Attachments:
Permalink Reply by davide recupero on August 11, 2014 at 7:50am

Thanks Daniel!!!
I was trying to do the same but I had not well understood the cluster.

Now it works perfectly.

Thanks again.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service