Problem with Gravity for Mesh in Kangoroo.

Hi everybody,

I did tensile membrane inside of the box using Kangoroo, everything but the gravity works good. I want to push this membrane a bit to the Earth with Z coordinate.

I am quite new in Kangoroo, I found a part of code which I think should work, but I really don't know how I need to connect it corrently to the main definition, or maybe I should be something different.

i would really appreciate any help in this question.

membrane.gh

Attachments:

Screenshot_4.jpg, 287 KB
Screenshot_5.jpg, 558 KB
code.png, 146 KB

Replies to This Discussion

Permalink Reply by Daniel Piker on May 10, 2013 at 2:21am

Try this

Attachments:

membrane2.gh, 32 KB

Permalink Reply by Francesca Boggio on May 10, 2013 at 2:37am

Hi Daniel, where I can find all your clusters? are available? thanks in advance.

Permalink Reply by Daniel Piker on May 10, 2013 at 2:52am

There is a folder of them that comes with the latest download from Food4Rhino http://www.food4rhino.com/project/kangaroo

They are .ghuser objects, and should be placed in your User Objects folder

Permalink Reply by Francesca Boggio on May 10, 2013 at 3:10am

thank you very much, I had not noticed this folder.

Permalink Reply by Dmytro Lutsak on May 10, 2013 at 5:04am

hi Daniel,

thank you for your help, but your new membrane2 definition had no anchros points so I cannot move the points how i need.

and one more question, any ideas how is it possible to work with meshes with more than 4-corners (i need not only typical 4 corners membrane, but with 5 or 6 cornerns and every anchros point i need to move for specific position).

any ideas?

RSS