problem with flip function

Do not know how to fix the entrance to the flip function.

thanks

Attachments:

repisa 4.3dm, 277 KB
repisa4.gh, 26 KB

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on January 27, 2012 at 3:47pm

Cleaning the tree should solve it:

Permalink Reply by fernando molas garcia on January 27, 2012 at 5:48pm

Thank you!

Now I have the following problem:

The list is checked contains 5 elements. I want to do all what I did with 3.

When connected to the planar function get an undesired result

Attachments:

repisa 5.3dm, 277 KB
repisa5.gh, 31 KB

Permalink Reply by Yoann Mescam (Systemiq) on January 28, 2012 at 1:49am

You need only 3 elements out of the 5 elements ? How do you decide which ones you want ?

Permalink Reply by fernando molas garcia on January 28, 2012 at 1:01pm

No, I need to use all the elements, that's the problem!. slider to apply the cuts applied only to one

Permalink Reply by fernando molas garcia on January 28, 2012 at 1:01pm

As you can see in the block above the definition of the problem for the "ribs" vertical is resolved,but no reason to raise it the same for the "ribs" horizontal had to make several modifications and stayed on the list in question. . . .
As I've deduced the ultimate aim of the definition is to solve the joints of the "ribs" horizontal and vertical cross in the middle.
thanks again and hopefully you can solve it
regards

Permalink Reply by lucas cañada on January 28, 2012 at 1:06pm

i dont know hot to flip an irregular matrix, i have fixed "manually" and create a new ordered list. Im sure there is a smarter solution and will be nice if someone will teach us, please ;)

Attachments:

repisa6.gh, 35 KB

Permalink Reply by fernando molas garcia on January 28, 2012 at 1:31pm

Impressive lucas! I study the definition to see how fix it!

Thank you very much!

Permalink Reply by fernando molas garcia on January 28, 2012 at 1:48pm

Lucas
I do not understand what you do before the function Weave, to "rebuild the surfaces

Permalink Reply by fernando molas garcia on January 28, 2012 at 2:11pm

Merge missing in this connection that makes the cuts are very deep!

provide connectivity as before but I get an error similar to what we had before. . . .

Permalink Reply by lucas cañada on January 28, 2012 at 2:34pm

before the wave i just make the an ordered list because planar were not consecutive you can check it with list item...

Permalink Reply by fernando molas garcia on January 28, 2012 at 2:49pm

lucas looks this arrangement will only add the Join function before making the surface ...

works but you have to fix the sorting order of the points that make up the polyline ...

Attachments: