problem with flip curve and guide curve

Hello,

I have a problem with the component flip curve (I would like all the curves to be in the same direction), the guide curve does not work (it's the first curve of the set) or I do not use it properly ?
Can you help me on this feature?

Thank you

Pierre

Attachments:

guide curve.gh, 35 KB

Replies to This Discussion

Permalink Reply by Chapulin Colorado on April 21, 2017 at 11:46am

hi,

i think normally you use it like this:

regards

Permalink Reply by Michael Johnson on March 6, 2020 at 8:21am

Hello Chapulin

I know its been a while since this thread has been active but I'm hoping for some help for a GH newb.

I know what most of the nodes in the image above are and how they are used, but I'm not sure about the last one, what its called, where to find it how to properly implement it.

if you have a GH file of it or can offer any insight it would be much appreciated.

Thanks

Permalink Reply by Chapulin Colorado on March 6, 2020 at 9:58pm

Hi,

the last one is just ti visualize the point order.

Its called something like point order I think.

For further questions I would recommend you the ne Grasshopper Forum, which is part of the McNeel forum: https://discourse.mcneel.com/

Permalink Reply by pierre m on April 22, 2017 at 1:45pm