Problem with energy simulation and HBzone creation

Hey guys,

I am getting sever errors for energy simulation and I don't know how to solve them. I created my HBzones and I fed them to energy simulation component. I am not getting any result and the error I am getting is :

1. The simulation has not run correctly because of this severe error:
** Severe ** GetSurfaceData: Zone ZONE_4 has only one floor, wall or roof, and this surface has a window.

My surfaces are all correct and I have put the right surfaces to right components. I searched this problem but I did not find any similar type. Do you have any idea that what might be my problem? I also attached my gh file.

I am looking forward for your answer and I appreciate your help.

Attachments:

energy_simulation_single_zone_coloring_surfaces_added.gh, 710 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on November 12, 2016 at 6:32pm

You either have to internalize the geometry or share the Rhino model. No one can help you just from the Grasshopper definition.

Permalink Reply by Mitra Sajjadi on November 12, 2016 at 9:06pm

Here is my rhino file. Thank you for mentioning that.

Permalink Reply by Mitra Sajjadi on November 12, 2016 at 9:30pm

I attached the rhino file. Thank you for mentioning that.

Attachments:

Sajjadi_Mitra.3dm, 3.8 MB

Permalink Reply by Devang Chauhan on November 12, 2016 at 9:40pm

Hi Mitra,

I took a look. You are not supplying closed BREPs to the Honeybee_Run Energy Simulation Component. I suggest you use Honeybee_createHBSrfs component to take your surfaces, and then make zone / zones from them.

Thanks,

Devang

Attachments: