Grasshopper

algorithmic modeling for Rhino

problem with divide surface

Hello everybody, that's the problem:
 I used loft components to make a surface, with some section curves.
I want to divide loft surface, and use "divide surface"..... but component turns red, there's error! I try different options with loft components but....error!
Does anybody know why?
I post rhino and grasshopper files.
Thank you everybody!

Views: 581

Attachments:

Replies to This Discussion

Permalink Reply by Sameer Kumar on March 22, 2010 at 7:08pm
This is because your lofted "surface" is in fact an open brep (a polysurface). The divide surface component would only accept surfaces. For example, you can plug your lofted brep output into an "Explode" component and connect the "faces" output into the divide surface component and it would work. Of course, it would divide each face individually.
Permalink Reply by cimmero on March 23, 2010 at 7:05am
Thank you Sameer, I try your solution.
then you say it's only a problem of close surface?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service