PROBLEM WİTH JOINNING CURVES

i am creating some curves by intersecting an angled surface and four spheres. Brep(BBX) is normally creating two circle from intersecting with the surface's flat sides and 4 arcs(angled half circles) from intersecting with angled edge of the surface. I am aiming to divide them to some segments. For examle if i wanted to divide to 4 pieces the curves from angles edge intersections are dividing into 8 segments.

I have tried to join curves to solve the problem but 'join curve' command didnt join the curves those ones are angled. the other ones were single closed curves already.

When i baked the join result that not joined or bbx curves and set them as multiple curves for an another 'join curve' the result was joined curves unlike algorithm based curve joint.

I would grateful for any help.

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 16, 2017 at 12:25am

your input curves ramain in their own data tree because you didn't flatten curve input for join.

Take a look at the attachment.

Attachments:

joinproblemtreetrus_re.gh, 25 KB

Permalink Reply by Ömer Faruk Aslan on August 16, 2017 at 2:35am

The problem is fixed owing to your help. Not only flatten problem but also my command to intersect surfaces and line was wrong. I was using SCX and that was creating other problems as i saw in your file you used BLX. Using BLX is an another solution.

THANKS for your useful help.

Attachments: