Grasshopper

algorithmic modeling for Rhino

prob with kangaroo definition

hi evereyone,

 

could someone help me , whats wrong with my definition...

i try to do a catenary line with kangaroo.

 

please have a look at the file.

http://www.woofiles.com/dl-210621-YmExfa6e-cantenarykangaroo.ghx

 

thank you !

Views: 313

Replies to This Discussion

Permalink Reply by Daniel Piker on November 2, 2010 at 3:19pm
See the attached file for a fixed version. The only thing missing was to connect the SubCrvs into the Springs input.
I also increased the damping a bit so it reaches equilibrium without too much bouncing about.

Hope that helps

Also - for any future Kangaroo questions, there is now a dedicated forum here on this site:
http://www.grasshopper3d.com/group/kangaroo
Attachments:
Permalink Reply by pyrit on November 2, 2010 at 3:48pm
thank you very much, appreciate the help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service