Possible bug: Cluster not showing when saved

Hi David,

I've attached the problem file.

I broke up my model into clusters as it was getting too complex to show all at once - no problems doing that, until I went in to create a surface-offset on a structural element (give some surfaces a thickness). What's weird is that the file works fine when inside the cluster, it is showing up as it's supposed to. However, when I save and exit the cluster back into the main model it no longer shows up. Any ideas here? There are no errors or warnings.

Thanks,

Ben

Attachments:

David.gh, 53 KB

Replies to This Discussion

Permalink Reply by BC on June 22, 2014 at 8:04pm

I was able to figure out a workaround, though it is still acting like a bug. Again, the file works fine when inside the cluster, but nothing shows up when I save/exit the cluster and come back into the main model. I was able to delete the output links and put in new ones, which fixed it. No idea why replacing those would have any effect.

Cheers.

RSS