Grasshopper

algorithmic modeling for Rhino

PolyLine of intersection points on each curve

Hi guys,

I want to first get the intersection points on each curve with the yz plane based on the points on the baseline, and set the whole points on the same curve into same branches, and then  to generate polylines. But the process seems not quite right when the polyline component started to keep warming.

I'll appreciate it if you give me a hand. 

Best wishes.

Xiaojian

Views: 405

Attachments:

Replies to This Discussion

Permalink Reply by Joseph Oster on November 6, 2017 at 6:45pm

Permalink Reply by Bi Xiaojian on November 6, 2017 at 6:49pm

Hi Joseph,

Thank you for your immediate reply. So the error is my curve sets, right?

Permalink Reply by Joseph Oster on November 6, 2017 at 6:55pm

What error?

Permalink Reply by Joseph Oster on November 6, 2017 at 7:40pm

OK, yes, I see the problem now with your curves - they are not what they appear to be.  Near the bottom, they are split in two, and the sequence is odd.

Use the 'path idx' slider on the 'Tree/List Viewer' to examine them.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service