Grasshopper

algorithmic modeling for Rhino

polygon to surface problem

Hi there!

I am trying to create a surface from a polygon but not able to do it. I apologize for my lack of command over grasshopper but I really need help.

I can't figure out this U count error. Can someone share their thoughts?

Skål!

Views: 1007

Attachments:

Replies to This Discussion

Permalink Reply by Joaquim Filipe Reis on September 2, 2013 at 7:30am

to obtain this result ?!

Permalink Reply by beta on September 2, 2013 at 7:36am

yes! actually the surface I am trying to create is a little more complicated so, thought to start with a basic one.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service