Grasshopper

algorithmic modeling for Rhino

POINT ON CURVE CONFUSION

EVEN THOUGH I REPARAMETISED I GET AN ERROR THAT PARAMETER IS TOO HIGH.

HOW DOES THIS "POINT ON CURVE" WORK?

Views: 247

Replies to This Discussion

Permalink Reply by Rémy Maurcot on March 6, 2013 at 3:06am

Hi pantelis.

Point on curve component gives an output point, what you want is a parameter value.

Rémy

Permalink Reply by pantelis apostolou on March 6, 2013 at 3:16am

thank you very much .. i was trying to find how to use this component ....

thanx again

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service