Grasshopper

algorithmic modeling for Rhino

Point grouping within branches goes wrong.

Dear all,

I would like to ask you a question about point grouping. I have a list of points, and when similar points are found within a branch, I want to use those indices to pick only one of the points within the pointgroup and mass addition the vectors from the list of vectors which has the same tree. With one branch of the tree it works just fine, but somehow not with the whole tree.

Could somebody help me? Much appreciated!

Kind regards,

Jeroen

Views: 381

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on December 14, 2015 at 12:42pm

Hi.

Check once -- I'm not sure if this was right or not.

Attachments:
Permalink Reply by Jeroen van Lith on December 14, 2015 at 2:30pm

Dear Hyungsoo,

thanks a lot! Will check tomorrow morning as soon as possible.

Greetings,


Jeroen

Permalink Reply by Jeroen van Lith on December 15, 2015 at 1:24am

It works very well. Thank you!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service