Grasshopper

algorithmic modeling for Rhino

point grid and criss cross pattern

i am making a criss-cross grid pattern in brick masonry. i have made with combining two grids but somthing went wrong. can somebody  help me, see the attched file below and pictures as well. i wanted to keep variation in group of brick that is either three or four or five. and i wanted to rotate the bricks in same course from center so that i can create opening in wall.

thanks in advance

Views: 1307

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on May 4, 2016 at 12:57am

Hi.

This is one simple allocation using "dispatch".

Attachments:
Permalink Reply by shreyas on May 4, 2016 at 2:40am

thanks a lot  Hyungsoo Kim.   and one more doubt i wanna ask to yu. how can i define this wall on double curved surface. see refrrace images

Attachments:
Permalink Reply by Hyungsoo Kim on May 4, 2016 at 2:49am

Try "Box Morph" or "Surface morph". Beware your bricks would be distorted.

Permalink Reply by shreyas on May 4, 2016 at 11:59am

thanks   Hyungsoo Kim .... i thied with this both commands but the bricks are getting distorted is there any other way to go.

Permalink Reply by shreyas on May 7, 2016 at 10:39am

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service