Plug-in does not want to start

Replies to This Discussion

Permalink Reply by David Rutten on February 21, 2013 at 3:07am

Hi Anton,

what happens when they drag the GHA file onto the canvas. Does a 'no-can-drag-here' mouse cursor appear?

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Anton Klimenko on February 21, 2013 at 3:32am

Hi David,

Thanks for your answer.

The problem is that they could not even see the tab with the plug-in.

Best Regards,

Anton

Permalink Reply by David Rutten on February 21, 2013 at 11:27am

Could it be that the tab is not visible until scrolled into view? I'd like a screencap (including the mouse-pointer) of the attempt of dragging a GHA file onto the canvas.

Also, another approach is to open the components folder (Grasshopper File menu, Special Folders -> Components Folder) and drop the GHA file there directly.

A Grasshopper+Rhino restart may be required after doing a manual install.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Anton Klimenko on February 21, 2013 at 4:36pm

Hi David,

Here is the screenshot.

Thanks in advance

Permalink Reply by David Rutten on February 23, 2013 at 7:16am

Hmm, can you upload (or email) me the onihRRstab.Gh.gha file? I'd like to see whether it tries to load it but fails.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Anton Klimenko on February 23, 2013 at 7:08pm

Hello David,

Thanks for your help.

I sent an email with plug-in to your address.

Thank you.

Permalink Reply by Anton Klimenko on March 9, 2013 at 5:10pm

Hello David,

Thank you for your help. We followed your advice and solved the problem. It was in the lack of libraries on the tester's computer.

Thanks again! 

Permalink Reply by Roman Bablowsky on February 21, 2013 at 2:56pm

I have to test the plugin but had the same problem - plugin tab didn't appeared after copying into the component library