Plug grasshopper in Rhino 4.0 SR3

Goodmorning everyone,

I work now on another computer where Rhino 4.0 SR3 is installed. When I tried to install grasshopper from grasshopper3d, I have an error message that told me that the pluggin is supposed to work with the latest release of rhino.

Do an old version of grasshopper, compatible with Rhino 4.0 SR3, exist? If yes, where can it be download?

Thank you very much,

Fanny

Replies to This Discussion

Permalink Reply by Fanny on July 15, 2010 at 8:01am

no one?

Permalink Reply by Carlos Pérez on July 15, 2010 at 10:53am

Hi Fanny,

The latest version of GH works only in V4SR8. Why don't you simply download SR8 from www.rhino3d.com/download.htm?

Regards,

- Carlos Pérez
McNeel Europe

Permalink Reply by Fanny on July 15, 2010 at 3:50pm

It is not my computer and some other pluggins, that works with the SR3 version are added. Does a version of grasshopper for earliest verso exist?

Best,

Fanny

Permalink Reply by Luis Fraguada on July 15, 2010 at 7:40pm

I do not remember using EH until sr4...but my memory is not so good...

Permalink Reply by Fanny on July 15, 2010 at 7:42pm

Ok, thank you. I will see what I can do so.

Permalink Reply by Paul N Jeffries on July 16, 2010 at 3:17am

I think that David only released grasshopper for SR4 onwards (and even those early versions are no longer available, I think).

The other plugins which need SR3 should still work with later service releases. As far as I know there has been no loss of backwards compatibility.

Permalink Reply by Fanny on July 16, 2010 at 5:05am

ok, so I will try to uprgrade rhino.
Thank you again

RSS